Steel Snakeskin Vest

The Snakeskin weave is based upon European Four in One, but with two alternating ring sizes. This vest uses punched mild steel washers and .064 1/4 inch galvanized steel rings. I made this one so that the weave hangs “open” to show off the flat solid rings more. This results in a stiffer shirt, but it is still flexible enough for comfortable wear (and curve hugging!). As pictured will fit up to a 44 inch chest, 18 inch bicep and is 26 inches long.

Anodized Aluminum European Four-in-One Footman’s Hauberk

When your LARP game goes on all weekend, you will appreciate that this shirt only weighs nine pounds. Traditional European Four-in-One weave made with .08 3/8th inch anodized aluminum rings. Special in-game bonuses vary by game organizer discretion. Pictured is a hauberk 26 inches long with sleeves that are 18 inches long and 14 inches around.

European Four-in-One Footman’s Hauberk (Version 2)

Twenty one pounds of European Four-in-One armor-grade (.08 3/8 galvanized steel) hauberk. I decided to use Kingsmaille for the brass Valnott inlay, to make it stand out more. Persian Three-in-One trim around neckline and hemline for an extra touch. In-stock size will fit up to a 40 inch chest, 14 inch bicep and is 36 inches from shoulder to hem.

European Four-in-One Vest

European 4-in-1 pattern sleeveless shirt made from .064 5/16th inch galvanized steel rings. These smaller, lighter rights still provide the same armor grade protection as the .08 3/8th inch rings used in other shirts, but it weighs only twelve pounds (it just takes longer to make). Contact me to discuss adding sleeves.